FreeCraftz.com presents:

STAR CANDLEHOLDER

from Painting On Jars by Cindy Trombley

www.paintingonjars.com

SUPPLIES:
One- 16 oz. Salsa jar
Contact paper, any color or design

BRUSHES:
1" and 2" foam brushes
Loew-Cornell 3/8" angular
Old toothbrush

FOR PRIMING JARS:
DecoArt-Americana- Ultra gloss paint, color chocolate

TO PAINT DESIGN ON:
DecoArt- Americana acrylic paint
True Ochre Raw Sienna
Dark Chocolate

TO SEAL JAR WITH:
Delta clear gloss glaze step #3

ALSO:
Micron Pigma Pen-black ink tip #05
Krylon Matt Spray finish #1311
1-1/2"x 18" fabric strip to wrap around rim of jar
6"x6" piece of contact paper


GETTING STARTED:

Trace 2 stars onto your contact paper.
Cut out and remove the backing. Place one star on each side of jar. Leave stars there
until all painting and glazing has been done.

Basecoat entire jar-also inside and outside of rim, with the Ultra-Gloss Chocolate paint.
I use a foam brush for this. This paint does not need to cure like the jars painted with the
flat house paint. Use a blow dryer in-between each coat. You will need to apply at least
2 coats in order to get good coverage, possibly 3.
When the last coat of the Ultra-Gloss chocolate is dry, apply the True Ochre over all of
the chocolate paint. Again a foam brush is fine for this application.
Apply as many coats as needed to cover the chocolate paint.
With the 3/8" angular brush, float Raw Sienna around the edge of each star. Also float
Raw Sienna around bottom of jar, at top of rim, inside and out. Let dry.

SPATTERING:
With an old toothbrush spatter entire jar with dark chocolate. When paint is completely
dry spray Krylon Matt spray finish #1311 around the edges of each star. Let dry.
With Micron Pigma pen make stitch marks around each star.
Make sure ink is completely dry and then spray the star again with the Krylon Matt
spray finish.

TO FINISH:
Apply the Delta Clear Gloss Glaze step #3, to your jar. Using a foam brush. Leave the
contact paper in place until the glaze is very dry. About 15-20 min. (with a blow dryer
about 2 to 3 min.) when jar is ready, use a needle or pin to pull one point of the star
away from the surface of the jar. Continue to pull until the star is completely off of the jar.

Fold fabric strip in half: tie around rim, cut tails to desired length.
Add a votive to the inside of the jar and you have a nice country candle holder!

By Cindy Trombley copyright 2001